dycas.blogg.se - Cisco asa 5505

IPSec microcode : #CNlite-MC-IPSECm-MAIN-2.04Ĭisco Adaptive Security Appliance Software Version ) SSL/IKE microcode: #CNlite-MC-IPSEC-Admin-3.03 Y88acs06 rev16 Gigabit Ethernet index 00 MAC:Įncryption hardware device : Cisco ASA-5505 on-board accelerator (revision 0x0)īoot microcode : #CNlite-MC-Boot-Cisco-1.2 Go to ROMMON prompt if netboot fails? y/n :Įnable passing NVRAM file specs in auto-boot mode? y/n :ĭisable display of BREAK or ESC key prompt during auto-boot? y/n :Ĭurrent Configuration Register: 0x00000040ĭefault configuration file contains 1 entry.Ĩ8E6095 rev 2 Gigabit Ethernet index 09 MAC: Below is what steps 4 – 8 actually look like on Cisco’s ASA 5505:Ĭurrent Configuration Register: 0x00000000ĭo you wish to change this configuration? y/n : y I won’t copy what’s in Cisco’s guide but I’ll add the following:ġ. Start at page 7 entited “Performing password Recovery for the ASA 5500 Series Adaptive Security Appliance. First I will assume you are using Cisco’s gudie for recovering your password located at. Otherwise, the default username and password is to leave both blanks.This blog will discuss how to reset the password on Cisco’s ASA 5505 Adaptive Security Appliance.

If you had an enable password set, you may need to enter that in the password box when you try to connect using the ASDM.

DHCP is enabled on the cisco device, and it’s internal IP address is now 192.168.1.1

The Cisco ASA has been reset to factory settings.

make sure that the outside line is plugged into port zero, and your pc is plugged into any of the ports 1-7.

You want to get back to the prompt that looks like: ‘ciscoasa(config)#’

hit spacebar when the ‘more’ is displayed.

Enter the password, or just press enter if there is no password set.

After you open connection, press enter a couple of times, and you should get a prompt like: ‘ ciscoasa>’.

In Windows 7, Putty is the preferred program.

Create a connection on Com1 using the terminal settings:

For Windows XP, hyperterminal is the preferred program.

The console port looks like a network jack. Connect the console cable to the serial port, plugging the other end into ‘ Console’ port on the ASA 5505.Following are the ways & steps to Factory Reset the Cisco ASA 5505 Firewall through Console –